GETTING STARTED
BEFORE USE:
Working conditions
Only apply at temperatures between +5°C and +40°C.
Surface requirements
Ensure that joints are clean, dry and free of dust, rust and grease. Absorbent substrates and synthetics should be pre-treated with Bison Silicone Primer.
Preliminary surface treatment
For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.
DURING USE:
Handling of packaging
Screw the cap from the tube and pierce the tube membrane with the point at the top of the cap in a twisting movement. Screw synthetic nozzle onto the tube and then cut diagonally.
Directions for use
Inject sealant evenly and slowly into the joint. Immediately smooth with a finger and soapy water. For bonding, join the parts within 5 minutes. After approx. 5 minutes, a surface skin will form. Bison High Temp reaches its high heat resistance after fully curing. The curing can be accelerated by heating the sealant to a maximum of 150°C.
Points of attention
Silicone hardens under the influence of humidity. Contact with humidity is therefore absolutely necessary during curing.
AFTER USE:
Stains/residue
Immediately remove stains with white spirit. Cured sealant can only be removed mechanically.
Storage conditions
Store in properly sealed packaging in a dry place at between +5°C and +25°C.
