GETTING STARTED
BEFORE USE:
Working conditions
Only apply at temperatures between +5°C and +40°C.
Surface requirements
The surface must be dry, clean and free of dust, rust and grease.
Preliminary surface treatment
For a good result, cover the joint’s edges with masking tape. If necessary, prevent three-sided bonding by filling the joint with a foam backer rod or PE film.
Tools
Apply cartridge with a Power Pistol. Multi Tool to open the cartridge and tooling the sealant.
DURING USE:
Handling of packaging
Use sealant gun to handle cartridge. Open the cartridge by cutting off the plastic nipple on the top side at the screw thread with a sharp knife. Screw on the nozzle and chamfer at the desired width.
Directions for use
Inject the sealant evenly into the joint and tool within 10 minutes with a putty knife of Bison Silicone Multi Tool, moistened with a soap solution. After approx. 15 minutes, a surface skin will form. Before putting plants and fish in the aquarium, bonded and/or jointed aquariums will need to air for 4-8 days. After that, the aquarium must have been filled with fresh water 3 to 4 times over a 24-hour time period.
Points of attention
Silicone cures under the influence of air humidity. Contact with air humidity is therefore absolutely necessary during curing. By applying masking tape along the joints completely smooth seams are achieved, remove the tape immediately after smoothing.
AFTER USE:
Stains/residue
Remove stains immediately with acetone. Cured sealant can only be removed mechanically.
Storage conditions
Store in properly sealed packaging in a dry place at between +5°C and +25°C.
